NewsArchive
02-05-2005, 10:42 AM
[Friday, February 04, 2005 6:02 PM]
Hi Friedrich,
I don't know if this is by design, but the password protection does
not stop the install unless the "Auto-veryfy Password" is checked. If
it is not checked, even if "Password Protected" is checked and
password has been set, the install simply runs it's course. I.e. just
setting up a password does nothing unless you check the "Auto-verify
Password".
I'm using build 1035 and the script was updated after being created in
build 1014 I think.
Also on the install progress screen I get a string that says [STR
PROG_ACTION13]
Also at the bottom of the "General Information" window - Project tab
there is a hidden link area that is active, but hidden<g>
Best regards,
Arnór Baldvinsson
Icetips Software
San Antonio, Texas, USA
Hi Friedrich,
I don't know if this is by design, but the password protection does
not stop the install unless the "Auto-veryfy Password" is checked. If
it is not checked, even if "Password Protected" is checked and
password has been set, the install simply runs it's course. I.e. just
setting up a password does nothing unless you check the "Auto-verify
Password".
I'm using build 1035 and the script was updated after being created in
build 1014 I think.
Also on the install progress screen I get a string that says [STR
PROG_ACTION13]
Also at the bottom of the "General Information" window - Project tab
there is a hidden link area that is active, but hidden<g>
Best regards,
Arnór Baldvinsson
Icetips Software
San Antonio, Texas, USA