Folder not found at installation run time

[NewsArchive]

I have built my install/setup exe and run it on another computer.

I get past the dialogs and it starts copying files and then says folder
"\wybatap" is not accessible or doesn't exist.

How do I find where in the script this is? It all works OK when I say
install for C7 but I get this error when installing on C6 (and I
probably should,) but I don't know how to find the line in question
that is failing.

I don't think I can debug on the machine I have SB7 on because clarion
6 is not installed there.

Is that the entire path that is shown in the message? or is it just
the last part of some path that is missing?

Thanks, Bob Roos

[NewsArchive]

Bob,

> I have built my install/setup exe and run it on another computer.
>
> I get past the dialogs and it starts copying files and then says folder
> "\wybatap" is not accessible or doesn't exist.
>
> How do I find where in the script this is? It all works OK when I say
> install for C7 but I get this error when installing on C6 (and I probably
> should,) but I don't know how to find the line in question that is
> failing.
>
> I don't think I can debug on the machine I have SB7 on because clarion 6
> is not installed there.
>
> Is that the entire path that is shown in the message? or is it just the
> last part of some path that is missing?

That means that a target folder variable value is empty. It's a line that
appends "\wybatap" to the value.

What you can try to do is to let the user start your setup.exe with the /E
command line switch (event logging mode) and then check the c:\sbevents.txt
to find out where a target folder variable is empty.

Hope this helps.

Friedrich