Problem with If Else and Dialog

[NewsArchive]

I have a very big problem with my setup dialogs to be displayed
regarding when and when not to!

When I run my setup in debug mode - If Else will grind properly recognized.
But when I start my normal setup - this ignores the loops and displays
dialogs that indicate he is not.
That is my knowledge with the old version works.

Dirk Büchel

[NewsArchive]

Dirk,

> I have a very big problem with my setup dialogs to be displayed regarding
> when and when not to!
>
> When I run my setup in debug mode - If Else will grind properly
> recognized. But when I start my normal setup - this ignores the
> loops and displays dialogs that indicate he is not.
> That is my knowledge with the old version works.

Nothing changed in this area and you can rollback to the old version to
verify this :)

Just create a small project that demonstrate the issue and send it to our
support. We can then tell you what causes it.

Friedrich

[NewsArchive]

Should read: "that demonstrates the issue"

BTW, after you rolled back to verify this, you can then web-update again to
the new version.

Friedrich

[NewsArchive]

Ok

I have make a small project and send this to the support.

Dirk Büchel