Setupbuilder 10 Set VAriable problem

[NewsArchive]

Hi,
Im setting some varibles using Get after the user selects the intall
directory and they are not seen in the next Dialog.
Please see image
Directory select is in dialog 2
At the end I Get the values and set the variables and adding a message I
verify the get is OK USERSERIAL is readed ok!
But in the nex dialog (USer Info) the variable is shown blank.
What am I doing wrong?
Thanks

--
*Alberto Michelis*
ARMi software solutions www.armisoftware.com <http://www.armisoftware.com>

[NewsArchive]

Alberto,

this is working as expected. See attached screemshots and the following
link:

http://www.lindersoft.com/projects/UserSN.zip

Hope this helps a bit.

Friedrich

[NewsArchive]

Cant do it, it is not shown in the (USer Info) the variable is shown blank.
I had to delete the User info dialog and Use a Edit Data dialog.
There it works.
May be its related to the Load User info? I have it uncheked and
userserial is still blanked.
Regards

*Alberto Michelis*
ARMi software solutions www.armisoftware.com <http://www.armisoftware.com>

[NewsArchive]

Hi Alberto,

> Cant do it, it is not shown in the (USer Info) the variable is shown
> blank.
> I had to delete the User info dialog and Use a Edit Data dialog.
> There it works.
> May be its related to the Load User info? I have it uncheked and
> userserial is still blanked.

So you compiled the project from my UserSN.zip and the serial number was
blank?

Friedrich